If you’ve seen lately that the heater isn’t blowing heat air in your Ford Taurus, you is perhaps ready for a Thermostat change. Thankfully, all you’ll need to alter the Thermostat in a Ford Taurus is a couple of instruments and about a half hour or so, and you’ll soon be again on the road.
Ford Taurus Thermostat Replacement Instructions
1. Flip the drain valve on the bottom of the radiator counterclockwise to empty the coolant out of your Ford Taurus into an appropriate container. Depending on the scale of the container, it may be essential to elevate the front end of your Taurus with a jack and decrease it onto jack stands, or use wheel ramps.
2. Comply with the upper radiator hose to the point the place it meets the thermostat housing on the entrance of the intake manifold. Loosen the hose clamp and pull the radiator hose off the water connection on the thermostat housing.
3. Take out the 2 bolts on the thermostat housing cover with a 13mm socket or wrench and take away the cover. Clean any previous gasket residue from the within of the thermostat housing cover. Pull out the outdated thermostat.
4. Insert the brand new thermostat into the thermostat housing with the spring-facet dealing with into the engine. Set up the brand new thermostat gasket. Use a twig adhesive to hold the gasket in place, if desired.
5. Reinstall the thermostat housing cover. Tighten the bolts to 89-124 in. lbs. Reattach the higher radiator hose to the thermostat housing. Be certain the drain valve on the radiator is closed.
6. Fill the radiator with new or reserve coolant. Start your Ford Taurus and allow it to warm as much as its normal working temperature. Test hoses and connections for leaks and tighten hose clamps to cease any leaks, if necessary. Add extra coolant as needed.
